Locksmith service
Safe Opening in San Diego
Most safes that will not open have a lost combination, a lost key, a dead keypad or a jammed bolt. We open home and small-business safes where they sit, and we try every method that leaves the safe whole first. If drilling is needed, the hole is small, and on most safes it is repaired so the safe locks again.
Typical price: $150 to $450 for a home safe, $300 to $800 if it has to be drilled and repaired. Full price table
- Common causes
- Lost combination or key, dead keypad, jammed bolt
- Drilling
- Last resort, small hole, repaired so the safe locks again
- What to have ready
- Photo ID and proof the safe is yours
- Try first
- A fresh battery of the type the keypad takes
When you need a safe opened
You need a safe opened when the usual way in has stopped working and you cannot fix it with a battery or the manual. It usually comes down to one of four things:
- Lost combination. Often a safe bought years ago, or one that came with a house or an estate.
- Lost key. Many small home safes have a key override, and that key is the one nobody can find.
- Dead or failed keypad. The battery has run flat, the keypad has stopped reading presses, or the wiring to the lock has failed.
- Jammed bolt work. The code is accepted, the lock clicks, but the handle will not turn. Something is pressing on the bolts, or a part inside has slipped.
Safe will not open? What to try before you call
Try a fresh battery first, then wait out any lockout. Both cost you nothing and fix a good share of electronic safes.
- Change the battery. Many electronic safe locks run on a 9 volt alkaline, but check the manual, because some take AA cells. The battery is usually reached from the outside of the keypad. Use a new, name-brand battery, not one from a drawer.
- Enter the code once, slowly. Press each button firmly. A weak battery can make a correct code fail.
- Wait out the lockout. Many keypads go quiet after several wrong codes in a row. The delay varies by lock, from about 5 to 15 minutes. Leave it alone until the time is up, then try once more.
- Take the weight off the bolts. If the lock clicks but the handle will not move, push the door firmly shut while you turn the handle. Things stacked against the door inside can bind the bolts.
Do not pry at the door or hit the lock. Many safes have a relocker, a spring-loaded part that throws an extra bolt if the lock is attacked. Once it fires, the safe is harder and more expensive to open.
How we open a safe
We start with the method that does the least damage and only move on when it fails. The order:
- Proof the safe is yours. Your license, plus a receipt, manual or address that links you to the safe, goes on the job sheet.
- A look at the lock. Mechanical dial, electronic keypad or key lock, and whether it has an override. That tells us which methods are open to us.
- Non-destructive methods first. Depending on the lock, that means working the key lock, powering or replacing the keypad, or opening a dial lock without damage.
- Drilling, as the last resort. If nothing else works, we drill one small hole at a precise point, open the lock through it, then plug the hole and repair or replace the lock.
- A test with you watching. We set a new code or combination with you and lock and unlock the safe several times.
Proof that the safe is yours
We open a safe only for the person who has the right to open it. Have your photo ID ready, plus one thing that connects you to the safe: the receipt, the manual with the serial number, or ID showing the address where the safe is. For a shop or office safe, the owner or a manager they have authorized should be there. For a safe that came with an estate, bring the paperwork that shows you can act for it.
Before you let anyone drill your safe, check that they hold a California locksmith license. Our guide on how to check a California locksmith license shows how.
Changing a safe combination
Change the combination whenever someone who knew it should no longer have it: a former employee, a roommate or the previous owner of the house. On most electronic locks you can do it yourself with the current code and the manual. A mechanical dial is changed with the safe open, using a change key, and one wrong step can lock you out. That is where we come in, along with replacing a keypad that keeps failing.
What changes the price of opening a safe, and our limits
The type of lock and how the safe has to be opened decide the price. A safe that opens once the keypad is swapped is the cheaper job. One that has to be drilled, then repaired, costs the most. You will find each range listed below, and the rest of our work on the price list. Our safe opening cost guide breaks down what goes into each bill.
We are honest about value. A light fire box can cost less to replace than to open. A large commercial or high-security safe may need a specialist, and we will tell you on the phone if yours is one we do not take on. We open safes in homes and small businesses across central San Diego, out east in La Mesa and at the coast in Point Loma.
What safe opening costs in San Diego
| Job | Typical price |
|---|---|
| Home safe opened: Lost combination, lost key or dead keypad | $150 to $450 |
| Safe drilled open and repaired: When it cannot be opened any other way | $300 to $800 |
| Electronic safe lock or keypad replaced: Lock included | $150 to $400 |
| Combination changed: Mechanical dial or electronic lock | $80 to $175 |
Typical San Diego prices between 8 am and 9 pm, travel included unless a service call is listed. The exact price depends on the lock or the vehicle, and you get it before work starts.
Cabrillo Locksmith charges the same prices every day of the week. See prices for every locksmith service
Sources
The laws and official pages behind the facts on this page. Each link opens the original document.
- Consumer guide to locksmith companies: who must hold a locksmith license, Bureau of Security and Investigative Services
FAQ
Safe opening questions
Can a locksmith open a safe without drilling it?
Often, yes. A lost key can usually be worked around through the lock, and many electronic keypads that seem dead only need power or a new keypad. Mechanical dial locks can sometimes be opened without damage too. Drilling is kept for safes where those methods fail or the lock itself has broken inside.
Will my safe still work after it has been drilled?
In most cases, yes. The hole is small and placed at a specific point, and once the safe is open it is plugged and the lock is repaired or replaced. The safe then locks again. On some cheap safes the repair costs more than a new safe, and we tell you that before we start.
My electronic safe beeps but will not open. What should I check?
Start with the battery. A weak battery can light the keypad and still leave too little power to move the lock. Fit a fresh one of the type your manual names, usually a 9 volt alkaline, and try your code once, slowly. If the keypad has locked you out after wrong codes, wait for the delay to finish.
How do you know the safe belongs to me?
We ask for photo ID and something that connects you to the safe or the place it sits, such as the purchase receipt, the manual with the serial number, or ID showing the address. For a business safe we need the owner or someone they have authorized. For an inherited safe, have the estate paperwork ready.
Can you change the combination on my safe?
Yes. Most electronic locks let you change the code yourself with the current code and the manual, so try that first. Mechanical dial locks are usually changed with the safe open, using a change key, and it is easy to get wrong. A combination change typically costs $80 to $175.
Is it worth opening a cheap safe or should I buy a new one?
It depends on the safe and what is inside. Opening a home safe typically costs $150 to $450, and drilling and repairing one costs $300 to $800. For a light fire box or a small hotel-style safe, a new one may cost less. We give you the price before any work starts, so you can decide.
Related services
Jobs that often go with safe opening
Call or get a quote
Tell us what happened
Call and say what happened. For a car, have the year, make and model ready. You get a range on the phone and the exact price before work starts.
(619) 940-1565- Open 8 am to 9 pm, every day
- Licensed and insured
- Serving North Park and 31 more San Diego neighborhoods and nearby cities, including La Jolla, Tierrasanta, La Mesa, National City and Coronado