Licensed and insured Mobile locksmith in North Park, San Diego · Open 8 am to 9 pm, every day

Commercial locksmith service

Panic Bar Installation and Repair in San Diego

A panic bar, or exit device, lets anyone open a latched door from inside with one push, without a key. We install and repair rim, vertical rod and mortise exit devices, add outside levers or key cylinders, and fix the latch and dogging faults that leave doors failing inspection. The price is set before we start.

Cabrillo Locksmith, licensed and insured Open 8 am to 9 pm, every day Updated

Typical price: $350 to $900 supplied and installed on a single door. Repairs $120 to $350. Full price table

What it is
A bar or pad that unlatches the door with one push from inside
Main types
Rim, vertical rod (surface or concealed) and mortise
Who sets the rules
The California Building and Fire Codes, enforced by the city
Common inspection fault
A latch that does not catch when the door closes

What a panic bar is

A panic bar is a horizontal bar or push pad across the inside of a door. Pushing anywhere on the active part pulls back the latch, so the door opens in one motion with no key and no handle to find. The trade name is exit device, and the code calls it panic hardware.

It exists so that a crowd can get out of a room quickly, even in the dark, even when people are pressed against the door. That is why the rules about it are strict.

Rim, vertical rod and mortise exit devices

There are three main types. The right one depends on whether the door is single or a pair, and how it is built.

Type How it latches Where it fits
Rim A latch on the device itself catches a strike on the door frame Most single doors; the simplest to fit and repair
Surface vertical rod Rods on the face of the door latch at the top, and usually the bottom Pairs of doors with no center post
Concealed vertical rod The same rods, hidden inside the door Pairs where the look matters; harder to service
Mortise A full mortise lock in a pocket in the door edge, worked by the bar Heavy-use single doors

On a fire-rated door, the device must be listed and labeled as fire exit hardware. It looks much like an ordinary panic bar but is built and tested for a fire door.

When California code requires a panic bar

The California Building Code sets where panic or fire exit hardware is required, and its current edition took effect on January 1, 2026. It is built on the International Building Code, the model code, and California can amend any section. In summary, the model code’s text says:

  • Assembly and educational spaces of 50 or more people. Swinging doors serving these rooms may not have a latch or lock other than panic or fire exit hardware. Assembly can include restaurants, bars and event spaces.
  • High-hazard buildings. Swinging doors in these occupancies need it regardless of the number of people.
  • Egress doors in general. They must open from the inside without a key, special knowledge or special effort, with limited exceptions, and manual bolts are not allowed except in limited cases.

There is a narrow exception that lets the main entrance of some businesses, such as offices and shops, have a key-operated lock, but only with conditions, including a sign on the door. Whether your door needs a panic bar depends on your occupancy and the room’s occupant load, which the plans or the city determine. Confirm it with the City of San Diego’s building officials or the fire department’s inspectors before you buy hardware. Outside the city, in National City, La Mesa or Coronado, ask that city’s building and fire officials. We install to what they require; we do not make that call for you.

Panic bar faults that fail an inspection

Most failed exit doors fail for a handful of reasons:

  • The latch does not catch. A weak closer or a moved strike leaves the door resting closed but unlatched.
  • Extra locks. Chains, padlocks, slide bolts or a deadbolt added to keep the door secure at night.
  • Dogging misused. Dogging left on a door that should latch, or dogging fitted to a fire door, where it is not allowed.
  • Damaged bar or end cap. Carts and hand trucks crack the end caps and bend bottom rods on vertical rod devices.
  • Blocked doors. Stock stacked in front of the door, or a mat that stops it opening.

If your worry is break-ins through the back door, the fix is better hardware on the door, not a second lock that traps people. Talk to us before adding anything.

Panic bar outside trim: getting in from the street

A panic bar works from the inside only. On its own, the outside of the door is flat, which suits an exit-only door. When staff need to come in that way, we add outside trim: a lever, or a pull with a key cylinder that unlocks the latch. The cylinder can be rekeyed to match your other locks or added to a master key system.

Getting a panic bar installed or repaired

  1. Tell us the door. Single or pair, steel, wood or aluminum, and whether it has a fire label on the hinge edge.
  2. Tell us what the inspector or fire official asked for, if you have a notice.
  3. We fit or repair the device and the closer, then test that the door latches on its own from fully open.

Aluminum and glass shop doors often take a narrow-stile exit device; the lock side of those doors is covered under storefront door lock repair. We work on exit doors from Downtown San Diego to National City. Before anyone works on your exits, you can check a California locksmith license.

What a panic bar costs in San Diego

Panic bars and exit devices prices in San Diego
JobTypical price
Panic bar supplied and installed: Rim exit device on a single door$350 to $900
Existing panic bar repaired: Latch, dogging or end cap$120 to $350
Outside lever or keyed cylinder added: So the door can be opened from outside$120 to $300

Typical San Diego prices between 8 am and 9 pm, travel included unless a service call is listed. The exact price depends on the lock or the vehicle, and you get it before work starts.

Cabrillo Locksmith charges the same prices every day of the week. See prices for every locksmith service

Sources

The laws and official pages behind the facts on this page. Each link opens the original document.

FAQ

Panic bar and exit device questions

Does my business need a panic bar?

It depends on how the building is classified and how many people a room is designed for. The model building code California's is built on requires panic or fire exit hardware on latched swinging doors serving assembly or educational spaces of 50 or more people, and in high-hazard buildings. Confirm your own door with the City of San Diego's building or fire officials.

Can I put a deadbolt or a chain on an exit door at night?

Not on a door that serves as a required exit while anyone is inside. The code requires exit doors to open from the inside without a key or special knowledge, and it does not allow manual bolts in general. Chains, padlocks and slide bolts are classic inspection failures. Ask us about outside trim instead.

What is dogging on a panic bar?

Dogging holds the latch pulled back so the door works as a simple push and pull during business hours. It is turned on and off with a key or a hex tool. Fire-rated exit hardware has no mechanical dogging, because a fire door has to latch every time it closes.

Can people get in from outside if there is a panic bar?

Only if the door has outside trim. A bare panic bar leaves a flat door outside, which suits an exit-only door. Adding a lever or a pull with a key cylinder lets staff unlock or open the door from outside, while the bar still lets everyone out from inside.

Why does my panic bar door not latch?

The usual causes are a closer that is too weak to push the door past the latch, a strike that has moved, a door that has dropped on its hinges, or dogging left on. Less often the latch spring inside the device is worn. We check them in that order, because the first ones cost less to fix.

Is a panic bar the same as fire exit hardware?

Not quite. Fire exit hardware is a panic device that is also listed and labeled for use on a fire-rated door. A fire door needs labeled fire exit hardware. An ordinary panic bar on a fire-rated door is not acceptable, even if it looks the same.

Related services

Jobs that often go with panic bars and exit devices

See all locksmith services

Call or get a quote

Tell us what happened

Call and say what happened. For a car, have the year, make and model ready. You get a range on the phone and the exact price before work starts.

(619) 940-1565

  • Open 8 am to 9 pm, every day
  • Licensed and insured
  • Serving North Park and 31 more San Diego neighborhoods and nearby cities, including La Jolla, Tierrasanta, La Mesa, National City and Coronado

Request a quote

Locked out right now? Call instead. The form is for jobs that can wait until we reply.

Call (619) 940-1565 Get a quote